Keys Fitness KF-2-5T Owner's Manual page 8

Assembly
5. Connect the console harness together.
One side of harness is coming from the left
upright. The other end is coming from the
console.
Connect the amplifier harness together.
One side of harness is coming from the left
upright. The other end is coming from the
console.
Attach the console onto the uprights by
sliding into the uprights.
NOTE: Make sure that the console har-
ness is inside of the upright and not being
pinched.
Secure the console to the uprights using
two bolts M10x25 and two washers #10
per side.
IMPORTANT PLEASE NOTE:
Tighten all hardware installed in Step 2
through Step 5.
6. Locate the left and right covers.
Secure the covers to the console using
three screws on each side.
NOTE: Make sure not to pinch or screw
through any wires when securing the left
handlebar.
Amplifier
Harness
Console
Harness
Figure 5: Securing Console Assembly to Uprights
Screw ST4.2x12
Figure 6: Cover Installation
8
Console
Washer #10
Bolt M10x25
Left Cover
Console
Right Cover