Theft Protection Keycard; Removing The Keycard; Preparing A Second Keycard - Blaupunkt Los Angeles MP71 Operating Instructions Manual

Theft protection KeyCard

The unit is supplied with a KeyCard.
The car radio can also be operated using a
second KeyCard.
If a KeyCard is lost or damaged, you can
purchase a replacement KeyCard from a
Blaupunkt dealer.
If you use two KeyCards, the second Key-
Card adopts the settings of the first KeyCard.
However, you have the option of storing the
settings for the following functions separate-
ly:
Station button presets, bass, treble, balance,
fader, loudness, traffic announcement vol-
ume, beep volume and equalizer settings.
Furthermore, the values that were set last for
the frequency range, tuned station, traffic in-
formation announcement, RDS, REG, scant-
ime, seek tuning sensitivity, power-on volume
and SHARX are all stored.
This means that after inserting your KeyCard,
you will always be provided with your per-
sonalized set of basic settings.
Inserting a KeyCard
button 1.
Press the
The control panel opens.
Insert the KeyCard as shown in the pic-
ture (arrow 1) with the contact surfaces
facing downwards.
3
1
THEFT PROTECTION
Carefully push the KeyCard together
with the KeyCard slide in the direction of
the arrow (2) until they reach their end
position.
Close the control panel (arrow 3).
Note:
If you insert a card which the unit does
not recognize, e.g. a cash card,
"WRONG KC" appears in the display.
Remove the incorrect card and insert a
KeyCard that the unit is familiar with.

Removing the KeyCard

To unlock the control panel,
button 1.
press the
The control panel opens.
Push the KeyCard together with the
KeyCard slide towards the right until
they reach their end position.
Remove the KeyCard from the control
panel.
Close the control panel.
Note:
As a precautionary measure against
theft, remove the KeyCard when leaving
the vehicle and leave the control panel
open.
For safety reasons, the control panel
must always be closed whilst the vehicle
is moving.

Preparing a second KeyCard

("Learning")
A second KeyCard can be prepared as an
additional KeyCard if the unit is being operat-
ed using the first KeyCard.
If you want to prepare a second KeyCard (a
process known as "Learning"),
insert the first KeyCard and switch the
unit on.
35