Activating Mute; Adjusting The Volume; Mute While Telephoning; Setting The Volume Of The Confirmation Beep - Blaupunkt Los Angeles MP71 Operating Instructions Manual

VOLUME

Adjusting the volume

The volume can be adjusted in steps from 0
(off) to 66 (maximum).
To increase the volume, turn the volume
control to the right.
To decrease the volume, turn the vol-
ume control to the left.
Setting the power-on volume
You can set the unit's default power-on vol-
ume.
Press the MENU button 8.
Keep pressing the
"ON VOL" appears in the display.
Set the power-on volume using the
buttons 7 or the volume control.
and
If you set the volume to a value less than "1",
"LAST VOL" appears in the display. This
means that the volume that was set before
the unit was switched off will be reactivated
when the unit is switched on.
Risk of serious injury! If the power-on
volume is set to maximum, the volume lev-
el can be very high when the unit is
switched on.
If the volume was set to maximum
before the unit was switched off and the
power-on volume is set to "LAST VOL",
the volume level can be very high when
the unit is switched on again.
Severe damage to your hearing can be
caused in both cases!
To close the menu,
press the OK button 5 or MENU but-
ton 8.
The settings are saved.
38
button 7 until

Activating mute

This feature allows you to instantaneously
reduce the volume (mute).
Briefly press button 2.
"MUTE" appears in the display.
Cancelling mute
Briefly press button 2.
or
turn the volume control 3.

Mute while telephoning

If your car radio is connected to a mobile tel-
ephone, the car radio's volume will be muted
as soon as you "pick up" the telephone. This
requires that the mobile telephone be con-
nected to the car radio as described in the
installation instructions.
If a traffic announcement is received during a
telephone call and traffic information priority
has been activated, the traffic announcement
will be played. For further details, please read
the chapter entitled "Traffic information".
Setting the volume of the
confirmation beep
For some functions you will hear a confirma-
tion beep if you keep a button pressed for
longer than two seconds, e.g. when storing a
radio station to a station preset button. You
can adjust the volume of this beep.
Press the MENU button 8.
Keep pressing the
"BEEP" appears in the display.
Set the volume using the
tons 7 or the volume control. "0"
means beep off; "9" means maximum
beep volume.
To close the menu,
press the OK button 5 or MENU but-
ton 8.
The settings are saved.
button 7 until
and but-