Selecting The Display Colour; Beep (After Key Operations); Theft Protection (Keycard); Optical Indication As Theft Protection - Blaupunkt Memphis DJ Operating Instructions Manual

Selecting the display colour

With DSC 5 the display colour can be
changed from orange to green to adapt it to
the dashboard lighting of your car.
To change the display, proceed as follows:
Press DSC 5.
Press the rocker switch
"COLOUR" lights in the display.
Press << >> G to change the colour.
Press DSC 5 to quit.

Beep (after key operations)

This car radio can release a beep to confirm
those key operations which require more
than 2 seconds before the respective functi-
on is activated. This beep can be switched
on or off.
For this, press the following buttons one
after the other:
DSC 5.
F until the display
Rocker switch /
D a shows "BEEP ON" or "BEEP
OFF".
Press the rocker switch << >> G to
switch between "BEEP ON" and
"BEEP OFF".
Press DSC 5 to quit.
28
Theft protection
This car radio can be operated only with a
KeyCard the code of which is stored in the
set (see figure. page 3).
An unauthorized KeyCard is not accepted
and the set cannot be put into operation.
If an incorrect KeyCard is inserted, "----" is
shown in the display.
F until
/
The car radio can no longer be operated.
"CARD" flashes after about 10 seconds.
Remove that KeyCard, insert a correct one
and switch the set off and on 1. The car
radio is ready for operation.
However, if the four dashes appear again, a
waiting time of 10 seconds is to be kept.
After the fourth erroneous input, the waiting
time extends to 1 hour.
After another 16 incorrect attempts the car
radio needs to be decoded by an authorized
service location, however, presentation of
the radio passport is a must. If the set is
switched off during the waiting period, the
waiting period commences anew after swit-
ching the set on.
(KeyCard)

Optical indication as theft protection

When your vehicle is stationary, a light emit-
ting diode can flash as optical warning.
Depending on how your car radio is con-
nected, you can adjust one of the following
three states with DSC 5.
Press DSC 5.
Press the rocker switch
"LED" and a number is shown in the
display:
LED 1 - The LED flashes, if the car
LED 2 - The LED flashes, if the car
LED 0 - The LED diode does not flash.
Select with << >> G.
Press DSC 5 to quit.
F until
/
radio is switched via the igni-
tion.
radio is not switched via the
ignition.