BMW R 1200 GS Adventure Rider's Manual page 114

Remove front wheel stand.
7
with OE BMW Motorrad
112
Integral ABS:
z Insert ABS sensor 2 in hole
and install screw 1.
The cable of the ABS
sensor could chafe
through if it comes into
contact with the brake disk.
Make sure that ABS sensor
cable is routed correctly.
Secure routing of ABS sen-
sor cable in clip 10.
Place brake calipers on
brake disks.
Install securing screws 3 on
left and right and tighten to
appropriate torque.
Brake caliper on slider
tube
22 lb/ft (30 Nm)
Remove adhesive tape from
wheel rim.
Braking efficiency is
impaired if the brake
pads are not correctly bedded
against the disks.
Before driving off, check that
the braking effect kicks in
without any delay.
Squeeze handbrake levers
forcefully several times.
The pressure point must be
clearly perceptible.
with OE BMW Motorrad
Integral ABS:
Switch on ignition.
Wait for ABS self-diagnosis
to complete.
Squeeze handbrake levers
forcefully several times.
The pressure point must be
clearly perceptible.
Removing rear wheel
Make sure ground is level
and firm and place motorcy-
cle on its center or auxiliary
stand.
Engage first gear.