Installation Of Fireplace; Things To Consider; Unpack The Refractory & Fireplace - Heat & Glo EXCLAIM-50 Owner's Manual

7 7

Installation of Fireplace

CAUTION! Risk of Cuts/Abrasions. Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.
A. Things to Consider
• Location of chimney air kit
• Location(s) of outside air kits
• Electrical connections and/or wall switch
• Gas line piping
B. Unpack the Refractory & Fireplace
• Remove back refractory from outside of fi replace by
bending tabs up and lifting refractory out of brackets.
See Figure 7.1.
• Bend tabs back down out of the way. See Figure 7.2.
• Do not remove screws or refractory brackets from
fi replace. If refractory brackets must be removed, fi ll
holes in outer shell with screws.
• Repeat this process to remove side refractories.
Figure 7.1 Unpack Back Refractory
Figure 7.2 Bend Refractory Brackets Back Down
20 Heat & Glo • EXCLAIM-50 • 4013-041 • Rev T • 08/08
• Remove screens by removing screw from end of each
screen rod.
Figure 7.3 Remove Screen Rods
• Remove hearth stone by removing three corrugated
shipping spacers (Figure 7.4). Lift hearth stone out of
fi replace. See Figure 7.5.
Figure 7.4 Shipping Spacers
Figure 7.5 Lifting Out Hearth Stone
• Remove fi replace from pallet:
- Remove screws from shipping brackets and pallet
(Figure 7.6),
- Replace screws removed from fi replace.
- Brackets can be used to anchor fireplace in
position.
Figure 7.6 Removing Shipping Brackets