Avaya QuesCom 400 Application Notes page 6

3.3. H.323 Trunks and Signaling Groups
The steps in this section create an H.323 IP trunk group to the QuesCom 400 IP/GSM.
Step
1. Enter the change node-names ip command. Specify the node name and IP address for the
QuesCom 400. Observe the node name of the C-LAN card shown in bold. These node names
will be used in the configuration of the H.323 signalling group in Step 4.
change node-names ip
Name
AEServer
Abacus
IPO412a_DC1
Quescom
S8300a_DC1
S8500_Val1
SEServer
clan1a_DC1
default
medpro1a_DC1
procr
2. Enter the add trunk-group n command, where "n" is an available trunk group number. On
Page 1 of the trunk-group form, configure the following:
• Group Type – set to "isdn".
• Group Name – enter a meaningful name/description.
• TAC – enter a Trunk Access Code that is valid under the provisioned dial plan.
• Carrier Medium – set to "H.323".
• Service Type – set to "tie".
add trunk-group 27
Group Number: 27
Group Name: H.323 Quescom
Direction: two-way
Dial Access? y
Queue Length: 0
Service Type: tie
HJP; Reviewed:
SPOC 9/14/2006
IP Address
10 .1 .10 .20
10 .1 .10 .31
10 .1 .20 .10
10 .1 .10 .55
10 .1 .30 .10
10 .1 .10 .14
10 .1 .10 .22
10 .1 .10 .12
0 .0 .0 .0
10 .1 .10 .13
10 .1 .10 .10
TRUNK GROUP
Outgoing Display? n
Busy Threshold: 255
Solution & Interoperability Test Lab Application Notes
©2006 Avaya Inc. All Rights Reserved.
Description
IP NODE NAMES
Name
Group Type: isdn
COR: 1
Auth Code? n
Member Assignment Method: manual
Page 1 of 1
IP Address
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
Page 1 of 21
CDR Reports: y
TN: 1 TAC: 727
Carrier Medium: H.323
Night Service:
6 of 27
QuescomACM_H323