Acoustic Warnings; Error Messages On The Screen - Fujitsu STYLISTIC Q584 Operating Manual

Acoustic warnings

Errors Acoustic error messages
Cause
A beep sounds every few seconds.
The battery is almost flat.

Error messages on the screen

Error message: Error messages onthescreen
This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
If the error message appears repeatedly, despite troubleshooting measures, please
contact the place of purchase or our customer service centre.
Error message/cause
CMOS battery bad
If the error message occurs repeatedly, the
buffer battery in the Tablet PC is flat.
System CMOS checksum bad - default configuration
used
The system configuration information is
incorrect.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory an error has
resulted at the address xxxx.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
Keyboard controller error
Keyboard error
nn Stuck key
Fujitsu
Troubleshooting
► Charge the battery.
Resolution
► Contact your sales outlet or our customer
service centre.
► Switch off the Tablet PC.
► Switch on the Tablet PC.
► Keep the volume – and shortcut buttons
pressed and switch the Tablet PC on. When
you boot while pressing the volume – button,
you can switch to the BIOS Setup.
► In the BIOS Setup, select the Exit menu.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter key.
► Contact your sales outlet or our customer
service centre.
► Start the BIOS Setup (Primary Master
submenu) and select the correct settings.
► Switch off your Tablet PC with the power
button.
► Wait 3 - 5 seconds and switch on the Tablet
PC again.
If you are using an external keyboard:
► Check the connection and reboot the Tablet
PC.
► Make sure that no key is pressed.
Troubleshooting and tips
79