Wireless LAN/Bluetooth/UMTS/LTE/NFC
radio components
The installation of radio components not approved by Fujitsu Technology Solutions
will invalidate the certifications issued for this device.
Switching the wireless components on and off
The wireless components are switched on and off via the corresponding operating system functions.
► To individually switch off and on the wireless components, select Settings –
Change PC settings – Network – Airplane mode.
Setting up WLAN access
•
Requirement: A WLAN must be available and you must have the
corresponding access information.
Information on configuring the WLAN access can be found in the
documentation for your operating system.
NFC
Your Tablet P is optionally equipped with an integrated NFC chip. Near Field Communication
allows a contactless, wireless exchange of data at a short distance (a few centemetres).
Access via UMTS / LTE
If you ordered an integrated UMTS / LTE module with your system, you can enjoy optimum
reception and maximum energy efficiency without awkward cables or antennas. The
optional UMTS / LTE module is ready for use straight away.
You will find information on establishing the connection with the UMTS / LTE network
in the documentation for the hardware used.
Your device can connect to the Internet via UMTS / LTE. To do this, use one
of the following types of connection:
•
Integrated UMTS / LTE module (availability dependent on your model variant)
•
a USB dongle (a USB stick with your mobile phone provider's SIM card)
•
a mobile end-device (e.g. mobile phone with Bluetooth or cable connection)
Fujitsu
Working with the Tablet PC
45