Table of Contents
Advertisement
UX-M55
Removing the CD mechanism
assembly
Remove the left and right side plates.
Remove the top cabinet.
Remove the front cabinet assembly.
1.
From the top side of the main body, disconnect the
wires from the four connectors CN601, CN602,
CN603 and CN701 on the CD & MCU board.
2.
From the left side of the main body, remove the tie
bands bundling the wires. (See Fig.14.)
3.
Disconnect the wire from the connector CN902 on
the power board. (See Fig.14.)
4.
From the left and right sides of the main body,
remove the four screws L retaining the CD rear
mounting bracket. (See Figs.14 and 15.)
5.
Slide the CD mechanism assembly toward the front
(in the direction of the arrow) and remove it from
the locking board support of the main board.
Removing the power board
Remove the left and right side plates.
1.
Disconnect the wires from the connector CN901 on
the power board. (See Fig.16.)
2.
Remove the tie bands bundling the wires.
3.
Remove the screw M retaining the lug wire.
4.
Remove the two screws N retaining the bottom
case. (See Fig.16.)
5.
Remove the power board by pinching the two
locking board supports retaining the power board
using radio pliers, etc. (See Fig.17.)
Power board
Fig.17
1-8
(See Figs. 13 to 15.)
(See Fig.13.)
(See Fig.15.)
(See Figs. 16 and 17.)
(See Fig.16.)
(See Fig.16.)
Radio pliers, etc.
Locking board support
Bottom case
CN603
CN701
CD & MCU board
CD & MCU board
CD rear mounting bracket
L
Locking board
support
Locking board supports
Power transformer
Bottom case
CN601
CN602
CD mechanism assembly
Fig.13
Tie bands
CN902
Power board
Fig.14
CD & MCU board
Main board
Fig.15
Main board
CN901
Tie bands
Lug wire
Power board
N
M
Fig.16
L
Hide quick links:
Advertisement
Table of Contents
