JVC UX-M55 Service Manual page 7

Removing the top cabinet
Remove the left and right side plates.
1. From the back side of the main body, loosen the
two screws F retaining the top cabinet. (See Fig.8.)
2. Lift the rear part of the top cabinet to remove it.
Removing the front cabinet assembly
Remove the left and right side plates.
Remove the top cabinet.
1. From the left side of the main body, remove the tie
band bundling the wires. (See Fig.10.)
2. Disconnect the wire from the connector on the
cassette switch board. (See Fig.10.)
3. Remove the screw G retaining the holder on the
earphone board. (See Fig.10.)
4. Disconnect the wires from the two connectors
CN607 and CN608 on the CD & MCU board.
5. Remove the four screws H and the two screws J
retaining the CD mechanism assembly from the left
and right. (See Figs.10 and 11.)
6. Remove the screw K retaining the front cabinet
assembly from the bottom side of the main body.
7. While opening the hooks d to the left and right of
the lower part of the front cabinet assembly (in the
direction of the arrows 1), slide the front cabinet
assembly toward the front (in the direction of the
arrow 2). (See Fig.12.)
8. Disconnect the wire from the connector on the
PB/REC head board, and then remove the front
cabinet assembly. (See Fig.10.)
[Note] After assembly, apply a locking agent to
the screws G, H and J.
H
J
CN607
CD & MCU board
Fig.11
(See Figs. 8 and 9.)
(See Fig.9.)
(See Figs. 10 to 12.)
(See Figs.10 and 11.)
(See Fig.12.)
CD mechanism
assembly
Fig.8
Lift the rear
part to remove.
F
Fig.9
CD mechanism
assembly
H
CD & MCU board
Connector on the
cassette switch
board
Power board
Fig.10
Bottom case
Hook d
Hook d
Fig.12
UX-M55
F
(To be loosened)
Top cabinet
Rear cabinet
H
CN608
J
G
Earphone
board
Holder
Tie band
Connector on the
PB/REC head board
1
Front cabinet assembly
2
K
1
1-7