Table of Contents
Advertisement
Removing the tray motor
Remove the CD & MCU board.
1.
From the top side of the CD mechanism assembly,
open up the claws b and c at the left and right of
the clamper assembly and lift the assembly to
remove it. (See Fig.4.)
2.
Push the section d of the elevator in the direction
of the arrow and lower the CD pickup assembly.
3.
Pull out the tray. (See Fig.5.)
4.
While opening up the claws e at the left and right
of the tray in the directions of the arrows, remove
the tray. (See Fig.6.)
5.
While pushing the claw f on the CD mechanism
assembly downwards, slide the elevator fully in
the direction of the arrow. (See Fig.7.)
6.
Lift the gear slightly, remove the transparent cover.
7.
Remove the belt from the tray motor pulley.
8.
Remove the two screws C retaining the tray motor
and remove it from the bottom side of the CD
mechanism assembly. (See Fig.7.)
[Notes] Take care not to attach grease on the
belt.
After attaching the tray motor in the
assembly, apply a locking agent to the
screws C.
(See Figs. 4 to 7.)
(See Fig.5.)
(See Fig.7.)
(See Fig.7.)
CD mechanism assembly
CD pickup assembly
CD mechanism assembly
Tray motor pulley
Tray motor
Clamper assembly
Claw b
Claw c
Claw c
Fig.4
Section d
Fig.5
Claw e
Tray
Claw e
Fig.6
Claw f
Transparent
C
Belt
Fig.7
UX-M55
Tray
Gear
cover
1-13
Hide quick links:
Advertisement
Table of Contents
