Vauxhall 2007 Vectra Operating & Safety Manual page 245

Picture no: 17745j.tif
4. Before attaching jack 3 set to required
height by turning the eye by hand. Fit the
jack 3 at the front – or rear – in such a
way that the jack head engages in the
plastic retainer beneath the vehicle.
Check that it is properly engaged.
The jack base must be on the ground
directly below the jacking point in a
manner that prevents it from slipping.
Ofrecido por www.electromanuales.com
Picture no: 17746j.tif
Attach crank to eye of threaded rod and
turn crank to raise vehicle.
If this is not the case, carefully lower the
vehicle immediately and reposition the
jack.
5. Unscrew wheel bolts and wipe clean with
a cloth. Then apply a light coating of
grease to the wheel bolts. Do not grease
the thread of the bolts. Do not put the
wheel bolts down in a location where
they may become soiled.
If the wheel bolts have retaining
washers 3, they must not be removed.
Self-help
Picture no: 17249t.tif
6. Change the wheel. Notes on spare
wheel – see page 236, notes on
temporary spare wheel – see page 237.
7. Screw in wheel bolts and tighten slightly,
inserting the wheel bolt wrench 3 as far
as possible.
8. Lower vehicle.
9. Tighten wheel bolts crosswise, putting on
wheel bolt wrench 3 as far as possible.
241
6