Crestron TPMC-V12-WALL Installation Manual page 14

Wall Mount Kits
10 • Wall Mount Kits:TPMC-V12-WALL, V12-WALL & WMKC-V12
Crestron TPMC-V12-WALL, V12-WALL & WMKC-V12
TPMC-V12-WALL and V12-WALL Procedure
This section provides the necessary steps for the installation of the
TPMC-V12-WALL or V12-WALL into a V12 mounting option. It is assumed that
wiring has been run and an appropriate V12 mounting option has been installed
according the instructions in the latest version of its Installation Guide.
Complete the steps in the order provided. The only tool required and not supplied is
a #2 Phillips screwdriver.
CAUTION: Allow an air gap of at least 12 inches (305 mm) in the wall cavity
above and below the touchpanel for heat dissipation.
NOTE: The illustration in this procedure shows the installation of the
TPMC-V12-WALL or V12-WALL with the BB-V12. Even though the illustration
only shows the BB-V12, the procedure is identical for other V12 mounting options.
1. If a cover plate is attached, use a #2 Phillips screwdriver to loosen and
remove the six screws and plate.
2. Connect all required cables to the touchpanel. Refer to "Hardware Hookup"
section of the TPMC-V12 & TPMC-V15 Operations Guide (Doc. 6940) or
the V12 & V15 Operations Guide (Doc. 6806). Both are available from the
Crestron Web site.
3. Insert the touchpanel (without its bezel) into the mounting option and align
the six screw holes. Do not handle touchpanel by the screen.
4. Insert and tighten the six included #06-32 x 1 1/2" screws (2007254) (finger
tight and then using a #2 Phillips screwdriver, tighten an additional
1/8-turn). Refer to the illustration on the following page.
Installation Guide – DOC. 6893B