Gigabyte W270BUQ User Manual page 207

Problem
The Wireless LAN/Bluetooth/3.75G/
HSPA modules cannot be detected.
The PC Camera module cannot be
detected.
The Wireless LAN/Bluetooth/
Camera/3.75G/HSPA modules cannot be
configured.
A file cannot be copied to/from a
connected Bluetooth device.
The Bluetooth module is off after
resuming from Sleep.
The modules are off. Check the LED indicator
to see if the WLAN/Bluetooth/3.75G/HSPA module is on or off (see
Indicators" on page 1 -
(WLAN), Fn + F12 (Bluetooth) or Fn +
in order to enable the modules (see
The module is off. Press the Fn + F10 key combination in order to enable the
module (see "Function/Hot Key Indicators" on page 1 -
application to view the camera picture.
PC The driver(s) for the module(s) have not been installed. Make sure you have
installed the driver for the appropriate module (see the instructions for the
appropriate module in
The transfer of data between the computer and a Bluetooth enabled device is
supported in one direction only (simultaneous data transfer is not
supported). If you are copying a file from your computer to a Bluetooth enabled
device, you will not be able to copy a file from the Bluetooth enabled device to
your computer until the file transfer process from the computer has been
completed
The Bluetooth module's default state will be off after resuming from the Sleep
power-saving state. Use the key combination (Fn + F12) to power on the
Bluetooth module after the computer resumes from Sleep.
Possible Cause - Solution
12). If the LED indicator is off, then press the Fn + F11
(3.75G/HSPA) key combination(s)
Table 1 - 6, on page 1 -
"Modules & Options" on page 7 -
Problems and Possible Solutions 8 - 11
Troubleshooting
and/or function key indicator
"LED
18).
18). Run the camera
1).
8