Canon imageFORMULA P-215 Service Manual page 76

CHAPTER 5 TROUBLESHOOTING
4) To cause neither jams nor skews.
Example: Blacken the leading edge of a A4
size or LTR size paper with a black
pen.
Use the sheet after the ink has dried.
Do not use a pencil.
The shading sheet may be used. Not
only one side, but also both sides may
be painted in black.
"A4 or LTR"
"Shading Sheet"
TKM-0326/0332
Figure 5-207
Note: If it stops in the middle when using A4
size or LTR size paper due to the
computer specifications, set to half the
size. Note that you should cut that
paper perfectly straight without any
slant.
5-6
Black region
2mm or more
Black region
2 to 4mm
COPYRIGHT © CANON ELECTRONICS INC. 2011
Operation Procedure
1) Clean feed path, roller, and reading glass.
2) Load a piece of the registration sheet you
prepared. Make sure to set the document
guides to fit the sheet to prevent skews.
Note: The black edge needs to be detected
as the leading edge of the sheet with
the front side sensor. Load the sheet
with the black-lined side facing down,
considering this black edge of the
sheet is the top of feed. Do not set
extra sheets.
Figure 5-208
3) On the service screen, select [Registration
Adjustment[Auto]].
Figure 5-209
CANON P-215 FIRST EDITION