iDect SOLO 5035+2 Owner's Manual page 59

"The phone does not ring"
 Check that the base unit's mains power adapter is plugged in and
power is switched on.
 The base unit needs mains power for normal operation of the phone –
not just for charging the batteries.
 Make sure that you are using the telephone line cable that was
supplied with your phone.
 Make sure that the ringer volume settings are not set to off. Increase
the ringer volume settings.
"My call was cut off when I went out of range. Now I can't use my
handset."
 Move the handset closer to the base unit before you try to make a call
again.
"There is interference and noise on the line"
 Move the handset closer to the base unit, or to a different position.
 Try moving the base unit away from other electrical equipment, such
as a television or a computer.
 You'll get the best reception if you place the base unit as high as
possible. For example, in a two-floor building, the upper floor is an
ideal place.
"I hear 'beeps' from my handset while I'm on a call"
 You may be moving out of range of the base unit. Move closer or your
call may be cut off.
 Check the Battery Level symbol on the display. If it's low, recharge the
batteries.
"The Caller Display feature isn't working"
 You need to subscribe to the Caller Line Identification service from
your network service provider.
 The caller may have withheld their number by dialling 1831. Or they
may be calling from a network that does not transmit the caller's
number (e.g. if they are making international calls.)
"When I try to make a call, I hear busy tone"
 If you're using a multi-handset system, check whether another
handset is already on a call.
"The volume in the earpiece is low when I'm on a call"
 Make sure you're holding the earpiece correctly over your ear.
 Adjust the volume using
"I cannot store a phonebook entry"
 The maximum number of 100 phonebook entries has been reached.
You must delete existing entries to make space for new ones.
+
.
57