Priority Scan Channel - Uniden UH038SX-2NB Owner's Manual

Operation

Priority Scan Channel

To set a priority scan channel:
1. Press SELECT / momentarily four times while in
standby mode to enter Priority Scan Channel
mode. The current priority channel will be
indicated.
2. Press or
desired channel number.
3. Press SELECT / three times to confirm and exit
to standby mode. PRI will be displayed when a
priority channel has been selected.
BCL (Busy Channel Lockout) On/Off
BCL is used when CTCSS or DCS is selected to prevent transmission
when the UH038SX-2NB detects a transmission from another unit using
the same CTCSS or DCS code.
To set BCL ON/OFF:
1. Press SELECT / momentarily five times while in
standby mode to enter BCL ON / OFF mode.
The current BCL status will be indicated.
2. Press or
3. Press SELECT / two times to confirm and exit to
standby mode. BCL will be displayed when BCL on
has been selected.
UNIDEN UH038SX-2NB
key to increase or decrease the
key to select ON (on) or OFF (oF).
11
UHF CB Transceiver