Blanking A Band Display; Automatic Band Change (Abc) - Kenwood TM-V708A Instruction Manual

BLANKING A BAND DISPLAY

If you have no plans to use one of band A or B, end the
frequency display on the unused band. This saves
power consumption and makes it simpler to read the
information presented.
Press the left [BAND SEL] (1 s) to blank band B, or the
right [BAND SEL] (1 s) to blank band A.
To restore Dual-band mode, press the same [BAND
SEL] (1 s).
Note: You cannot operate the blanked band nor use this band to
receive or transmit.
14
64

AUTOMATIC BAND CHANGE (ABC)

ABC will temporarily switch the RX only band to the TX
band immediately after a signal is received on the RX
only band. This function allows you to reply to a caller
without manually selecting the correct band.
Press [F], [A.B.C.] to switch the function ON (or OFF).
• "A.B.C." appears when this function is ON.
• Pressing [BAND SEL] or Mic [PTT] cancels ABC.
• The original TX band is restored 2 seconds after the signal
drops out.
Note:
◆ You cannot use ABC when in Single-band mode. After activating
ABC, changing from Dual-band mode to Single-band mode
switches the ABC OFF.
◆
After activating ABC, starting Visual Scan deactivates ABC.
Canceling Visual Scan reactivates ABC.