Using Program Scan; Mhz Scan - Kenwood TM-V708A Instruction Manual

■

Using Program Scan

1 Select the appropriate band.
2 Press [VFO] .
3 Select a frequency within the programmed scan
limits, including the frequency limits.
4 Press [VFO] (1 s).
• Scan starts at the frequency currently displayed.
• The 1 MHz decimal blinks while scanning is in
progress.
• To reverse the scan direction, turn the Tuning
control clockwise (upward scan) or counterclockwise
(downward scan). You can also press Mic [UP]/
[DWN].
5 To exit Program Scan, press [VFO] again.
Note:
◆
If the step size of the current VFO frequency differs from that
of the programmed frequencies, VFO scan starts instead of
Program Scan.
◆
If the step size differs between the lower limit and the upper
limit, VFO scan starts instead of Program Scan.
◆
If the current VFO frequency is within more than one
programmed scan range, the range stored in the smallest
channel number is used.

MHz SCAN

MHz Scan monitors a 1 MHz segment of the band, using
the current frequency step size. The current 1 MHz digit
determines the limits of the scan. For example, if the
current frequency is 145.400 MHz, then the scan range
would be from 145.000 MHz to 145.995 MHz. The exact
upper limit depends on the current frequency step size.
1 s
1 Select your desired band.
2 Press [VFO] to select VFO mode.
3 Select a frequency within your desired 1 MHz
segment.
4 Press [MHz] (Tuning control) (1 s).
• Scan starts at the frequency currently displayed.
• The 1 MHz decimal blinks while scanning is in progress.
• To reverse the scan direction, turn the Tuning control
clockwise (upward scan) or counterclockwise
(downward scan). You can also press Mic [UP]/ [DWN].
5 To exit MHz Scan, press [MHz] again.
9
51