Sony DVP-NC600 Operating Instructions Manual page 67

n
AUDIO DRC (Dynamic Range
Control) (DVD only)
Makes the sound clear when the volume is
turned down when playing a DVD that has
the AUDIO DRC function. This affects the
output from the following jacks:
-LINE OUT L/R (AUDIO) l/2 jacks
-DIGITAL OUT (COAXIAL or OPTICAL)
jack only when "DOLBY DIGITAL" is set
to "D-PCM" in "DIGITAL OUT" (page
67).
STANDARD
Normally, select this position.
TV MODE
Makes the low sounds clear
even if you turn the volume
down. It is especially
recommended when you listen
to the sound using the speakers
of the TV.
WIDE
RANGE
Gives
you the feeling of being at
a live performance. When you
use
high quality speakers, it is
even more effective.
WDOWNMIX (DVD only)
Switches the mixing down methods when
you play a DVD on which rear signal
components such as LS, RS, or S are
recorded in Dolby Digital format. For details
on the rear signal components, see
"Changing the Sound" (page 49). This
function affects the output of the following
jacks:
-LINE OUT L/R (AUDIO) l/2 jacks
-DIGITAL OUT (COAXIAL or OPTICAL)
jack when "DOLBY DIGITAL" is set to
"D-PCM" in "DIGITAL OUT" (page 67).
DOLBY
SUR-
ROUND
Select this when the player is
connected to an audio component
that conforms to Dolby
Surround
(Pro Logic). The output signals
which reproduce the Dolby
Surround effect are downmixed
to 2 channels.
NORMAL
Select this
when the player is
connected to an audio component
that does not conform to Dolby
Surround (Pro Logic). All of the
output signals are downmixed to
2 channels without the Dolby
Surround
(Pro Logic) effect.
HDIGITAL OUT
Selects if audio signals are output via the
DIGITAL OUT (COAXIAL or OPTICAL)
jack.
1
ON
Normally, select this position. When
you select "ON," set "DOLBY
DIGITAL" and "DTS." For details on
setting these items, see "Setting the
digital output signal."
OFF
The player does not output the
audio
signals via the DIGITAL OUT
(COAXIAL or OPTICAL) jack. The
influence of the digital circuit upon
the analog circuit is minimal.
Switches the method of outputting audio
signals when you connect the following z
component using a coaxial digital or optical
g
digital cord via the DIGITAL OUT
P)
(COAXIAL or OPTICAL) jack.
2
-Amplifier (receiver) with digital input jack
-Amplifier (receiver) with a built-in DTS or
2
z
DOLBY DIGITAL decoder
2
-MD or DAT deck
3
For connection details, see page 20.
g
Select "DOLBY DIGITAL" and "DTS" after D
setting "DIGITAL OUT" to "ON."
67