Program Recording (Cd = Tape) - Kenwood HM HM-332 Instruction Manual

Program recording
Desired CD tracks can be programmed in the desired sequence and recorded onto a tape.
Be sure to put the cassette deck in stop mode.
1
Make the preparations for recording.
1 Perform steps 1 to 3 of the procedure in
"Recording on tape".
2 Insert disc in the CD player.
2
Program the desired sequence of CD
tracks.
Perform steps 1 and 2 of the procedure in
"Listening in the desired sequence (Program
playback)".
3
Start recording.
To interrupt a recording
(Recording and playback will be
stopped.)
(CD = TAPE)
¢
§
TAPE O.T.E.
STOP
Convenient Recording Methods
÷ When the PGM/AUTO/MONO key is pressed to cancel
the edited contents, the entire editing contents will be
erased.
÷ Tracks programmed beyond the available tape recording
time will be interrupted in the middle.
÷ Operation is also possible with the o.t.e. key of the main
unit.
At the end of the recording
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.
Note that this cassette deck cannot record onto
Metal tapes.
Note Note Note
35