Start Recording - Kenwood HM HM-332 Instruction Manual

menu
up
volume/
multi control
down
set/demo
Select an input source other
than "TAPE"
Example:
To select the CD input
CD
6
4 4
TAPE rec
5 5
Pause the recording
TAPE rec
÷ Press the TAPE rec key during recording. It stops after
leaving a non-recorded blank of 4 seconds. (Press the
key again to resume recording.)
Stop the recording
STOP
7
Note that this cassette deck cannot record onto
Note Note
Metal tapes.
3. Set the recording condition.
Select the reverse mode.
÷ The tape equalizer is defeated during recording.
3 3
4. Select the source to be recorded.
CD
TUNER (Broadcasts)
AUX (External input)
"Adjusting the AUX input level"
÷ If a CD has already been loaded, it starts to play now. Press the 7STOP key
to stop it.

5. Start recording.

1 Press the TAPE rec key.
2 Play (or tune) the input source to be recorded.
÷ Recording stops automatically when the tape side(s) to be recorded have
been fully recorded.
Blinks
TAPE
REC
(
C
‡
The character information
display shows the recording
input source.
Points in CD recording
When recording CD tracks onto a tape, if you leave
the cassette deck in record-pause mode beforehand,
the cassette deck recording can be started at the
CD starts to be played.
1 Put the CD player in pause mode.
2 Select the track to be recorded with the
4 or ¢ key.
(The CD player pauses at the beginning of
the selected track.)
3 Put the cassette deck in Record-pause
mode.
(Press TAPE rec key twice)
4 Start playing the CD.
(Recording starts)
÷ To stop recording, press the 7STOP key.
Do not use a cassette with more than 90-minute record-
ing time, for the tape used with such a cassette is very
thin and tends to cause troubles such as entanglement
around the pinch roller or cutting of tape.
Recording on tape
01 0:00
D
25