Maintenance - Tunturi PURE RUN 3.1 User Manual

MAINTENANCE

The equipment is safe to use only when
periodically maintained and inspected
for faults and wear.
CAUTION!
Do not attempt any servicing or
adjustment other than those described
in this manual. Any other servicing must
be performed by an authorized service
representative. Check the tightness of
all fixing screws once a year. Do not
overtighten.
CLEANING AND LUBRICATING THE
TREADMILL
FA I L U R E TO L U B R I C AT E Y O U R
T R E A D M I L L M AY I N VA L I D AT E T H E
P R O D U C T ' S WA R R A N T Y !
Wipe the treadmill surfaces, especially
the handlebars and console from dust
with a damp cloth or towel. Do not
O W N E R ' S M A N U A L
use solvents. Use a small vacuum
nozzle to carefully vacuum around all
visible components (belt, running deck,
side rails etc.). Also keep the area
near the treadmill clean. While in use,
the treadmill gathers dust that may
cause problems in the operation of the
equipment.
In average domestic use (60 minutes a
day), you should check the lubrication
once a month – however, lubricate the
belt only if needed. In more demanding
use, the lubrication needs be checked
at shorter intervals. This is best done
before you begin a training session.
Check the lubrication as follows:
• Ensure the treadmill is powered off!
• Step on the treadmill belt .and stand
steadily where you normally run on
the belt.
• Take hold of the horizontal handlebar
and push the belt with your feet so
that it slides back and forth.
• The belt should move softly and
evenly, without a sound.
If you notice jerky movement or if the
belt will not slide check for lubrication by
sliding your hand under the belt.
LUBRICATE THE RUNNING DECK
ACCORDING TO THE FOLLOWING
INSTRUCTIONS:
1. Attach the nozzle of the lubrication
tube to the T-Lube S container.
2. Lift the running deck and lock it.
3. Position the nozzle between the belt
and the board. Try to reach the spray
as far into the center of the running
deck as possible.
4. Spray the lubricant for 2-3 seconds.
5. Lower the running deck into its
normal position. Use treadmill for
your training session. Or allow the
treadmill to run for at least 5 minutes
at 5KM/H ( 3Mile/H).
NOTE!
Lubricate your treadmill only with T-Lube
S silicon lubricant. Contact your local
Tunturi distributor for further supplies
of T-Lube or further information on
lubrication and maintenance.
GB
•
P U R E R U N 3 . 1
11