Water inlet fault
Problem
The Inlet/Drain indica‐
tor flashes on and off.
The dishwasher stops
during a programme.
The Inlet/Drain indica‐
tor flashes.
Fault code or ap‐
pears in the display.
Cause and remedy
The stopcock is closed.
Open the stopcock fully.
Before rectifying the problem:
Switch the dishwasher off with the button.
The water intake is restricted.
Open the stopcock fully and start the programme
again.
Clean the water inlet filter (see "Maintenance").
The water pressure at the intake is lower than 30
kPa (0.3 bar).
Seek professional advice.
Problem solving guide
67