Set The Subnet Mask - Roland LEC-300A Setup Manual

8. Network Settings
2.

Set the subnet mask.


NETWORK
SUBNET MASK

SUBNET MASK
000 . 000 . 000 . 000

SUBNET MASK
255 . 000 . 000 . 000

SUBNET MASK
255 . 000 . 000 . 000

SUBNET MASK
255 . 255 . 255 . 000

W 736 mm
SETUP SHEET
ROLL
If you're using one computer and one machine, this completes the settings to make on the printer. Go
on to Step 3.
If setting the gateway address is required, then go on to the procedure following this one.
3.
Set the gateway address.

NETWORK
GATEWAY ADDR.

GATEWAY ADDR.
000 . 000 . 000 . 000

GATEWAY ADDR.
255 . 000 . 000 . 000
58
Press .
Press twice.
Use to select the address number.
[Subnet mask] : 255.255.255.000
Note: For the subnet mask, make the setting the same value
as the one used by the computer. Here, "255.255.255.000" is
entered by way of example.
Press .
 
Repeat and to set the subnet mask.
When you've finished making the setting, press
.
Press .
Press to go back to the original screen.
1.
From the screen
Press twice.
Use to select the address number.
[GATEWAY ADDR.] : 255.255.255.255
Note: For information about the value to enter for the
gateway address, consult your network administrator. Here,
"255.255.255.255" is entered by way of example.

- , press twice.