Drive Mounting - Seagate Constellation ST4000NM0033 Product Manual
Es.3 serial ata
Hide thumbs
Also See for Constellation ST4000NM0033:
- Product manual (88 pages) ,
- Product manual (56 pages)
Table of Contents
Advertisement
3.4
Drive mounting
Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-
mounting holes. See Figure 11 for drive mounting dimensions. Follow these important mounting precautions when mounting
the drive:
• Allow a minimum clearance of 0.030 in (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.150 in (3.81mm) into the bottom or side mounting holes.
• Do not overtighten the mounting screws (maximum torque: 6 in-lb).
• Do not cover breather hole on top cover.
Breather Hole
Do Not
Cover
• Breather hole location - top cover
Constellation ES.3 Serial ATA Product Manual, Rev. E
27
Advertisement
Table of Contents
