Inspect All Fasteners - Precor Experience Strength General Safety & Maintenance Manual

Diagram 13: If needed, lubricate the pivot pin on the ratcheting seat lever
If desired, you can detach the seat by removing the retaining pin,
allowing you to remove the chrome for cleaning. Removing the seat
also allows clear access to the ratcheting lever to test its pivoting
action.
General Safety and Maintenance Manual: Monthly Inspection

Inspect All Fasteners

Precor products are assembled with Grade 5 fasteners or better.
With normal use, these fasteners can loosen. Inspect all nuts,
bolts, hex key bolts, screws, and other fasteners to make sure they
are tight and installed correctly.
Be sure to check fasteners at bolted joints to make sure the
connection is secure. If the fastener is loose, but in good condition,
retighten it. If you are concerned about the integrity of the fastener,
remove it, clean the threads, and inspect it for any damage such as
cracks, bad threads, corrosion, or rust. Reinstall the fastener if it
appears to be in good condition. Otherwise, remove the equipment
from service until a new fastener can be installed properly. You can
order new fasteners from Customer Support. Refer to
Service .
Obtaining
20