Checking After Adjustment - Sony SLV-L45AR Service Manual

Video cassette recorder
Hide thumbs Also See for SLV-L45AR:
Table of Contents

Advertisement

4-3-5. CHECKING AFTER ADJUSTMENT

1) Play the alignment tape (NTSC: KRV-52NE, PAL: KRV-
52PL) and check that the envelope waveform is
activated immediately and that there are no fluctuations
in the envelope waveform or the audio output wave-
form.
2) Load a cassette tape (NTSC:T-120, PAL: E-180) and
use it to record and replay. Check that the envelope
waveform is activated immediately and that there are
no fluctuations in the envelope waveform or the audio
output waveform. (When recording on the tape, input
1kHz to the audio input terminal. Use a scratch-free
cassette tape (NTSC: T-120, PAL: E-180).) Check that
at the tracking centre, the front half down and back half
down are not more than 20% of the value at the point
where the envelope waveform amplitude is at its
maximum.
3) Check that the envelope waveform is activated immedi-
ately when you switch from PLAY to R-SEARCH or
from R-SEARCH to PLAY. Check that there is no slack
in the tape next to the pinch roller.
4) Check that the envelope waveform is activated immedi-
ately when you switch to PLAY from FF, REW, F-
SEARCH, R-SEARCH or STOP mode. Check that there
is no slack in the tape next to the pinch roller.
5) Check that the tape is not curling or riding up on the
upper or lower flanges of the tape guides in PLAY, FF,
REW, F-SEARCH or R-SEARCH modes.
6) Check that in PLAY mode. the tape runs as shown in
Fig. 4-3-7.
7) Load a tape (NTSC:T-160, PAL: E-240) and play it
back. carry out the checks described in steps 3) to 5)
above.
S tape guide
No. 0 tape
S guide
guide
roller
BT post
Full erase
head
Audio R/P head assembly
(ACE head)
Cylinder
(drum)
T guide roller
5-29 E
Loading guide
T tape guide
post
Pinch roller
Capstan shaft
Fig. 4-3-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Slv-l65hfarSlv-l75hfar

Table of Contents