Channel Display - Kenwood TH-F6A Instruction Manual

CHANNEL DISPLAY

While in this mode, the transceiver displays only
memory channel numbers (or memory names if
stored) instead of frequencies.
1 Press [A/B]+[ ] (POWER).
• The transceiver displays the memory channel
number in place of the operating frequencies.
2 Turn the Tuning control or press [ ]/ [ ] to select
your desired memory channel number.
While in the Channel Display mode, only the following
keys can be operated.
[KEY]
L A M P M O I N L O W
S Q L B A L R E
C A L L 1 P T T
T u n n i g c o n r t l o
1
When the "1750" is selected for the CALL key.
[F] then
L A M P 1 L O W A B /
1
The light stays ON until the key is pressed again.
[KEY] (1 s)
L A M P N I F O M H
While transmitting:
L A M P M N U 1
5 6 7
# A
When the transceiver is turned OFF, [
and
A B / F
To recover normal operation, turn the transceiver
OFF and press [A/B]+[
Note:
To enter the Channel Display mode, you must have at least one
memory channel that contains the data.
If the memory channel contains the memory name data, the
memory name is displayed in place of the "CH" characters.
B A N D A B /
V E N T F
E N T F
z F M R
2 3
8 9
B C
] (POWER)
] (POWER) again.
N I F O
M R
4
0
D
6 MEMORY CHANNELS
21