Table of Contents
Advertisement
6 MEMORY CHANNELS
INFORMATION CHANNELS
10 Information channels are available for storing
radio broadcasting service frequencies, such as
community FM broadcasting stations. For your
conveniences, pressing [INFO] instantly recalls the
Information channel to B-band.
REPROGRAMMING THE INFORMATION CHANNEL
1 Press [VFO].
2 Select a desired frequency and mode.
3 Press [F].
4 Turn the Tuning control or press [ ]/ [ ] to select
the memory channel (I–0 to I–9) in which you want
to store the data.
5 Press [MR] ([ ] or [MNU]).
•
A long beep sounds and the Information
channel data is now revised.
Note:
◆ When you perform the Full reset {page 47}, all the Information
channels recover the factory default values.
◆ If you clear an Information Channel data {page 16}, the
factory default value is recovered.
◆ You can also transfer the Information Channel data to the
VFO or another memory channel.
RECALLING AN INFORMATION CHANNEL
Press [INFO] to recall the Information channels.
•
"I–n" appears, where "n" represents the
Information channel number from "0" ~ "9".
•
If the B-band is selected for operation, you can
turn the Tuning control or press [ ]/ [ ] to select
other Information channels. If the A-band is
selected for operation, press [A/B] to move the
operation band to the B-band and then select a
different Information channel.
•
To exit the Information channel mode, press [A/B]
to select the B-band then press [VFO] or [MR].
Note:
◆ If you press [MN<->f], you can display the receiving
frequency in place of the memory name.
◆ As default, no frequency data is stored in the Information
channel. Store the frequency data before using the
Information channels. Otherwise, an error beep sounds.
20
CHANNEL DISPLAY
While in this mode, the transceiver displays only
memory channel numbers (or memory names if
stored) instead of frequencies.
1 Press [A/B]+[
] (POWER).
•
The transceiver displays the memory channel
number in place of the operating frequencies.
2 Turn the Tuning control or press [ ]/ [ ] to select
your desired memory channel number.
While in the Channel Display mode, only the following
keys can be operated.
[KEY]
L
A
M
P
M
O
I N
L
O
W
S
Q
L
B
A
L
R
E
V
C
A
L
L
1
P
T
T
T
u
n
n i
g
c
o
n
r t
l o
1
When the "1750" is selected for the CALL key.
[F] then
L
A
M
P
1
L
O
W
A
B /
1
The light stays ON until the key is pressed again.
[KEY] (1 s)
L
A
M
P
N I
F
O
M
H
While transmitting:
L
A
M
P
M
N
U
1
5
6
7
#
A
When the transceiver is turned OFF, [
and
A
B /
F
To recover normal operation, turn the transceiver
OFF and press [A/B]+[
Note:
◆ To enter the Channel Display mode, you must have at least
one memory channel that contains the data.
◆ If the memory channel contains the memory name data, the
memory name is displayed in place of the "CH" characters.
B
A
N
D
A
B /
N I
E
N
T
F
E
N
T
F
z
F
M
R
2
3
8
9
B
C
] (POWER)
] (POWER) again.
F
O
M
R
4
0
D
Advertisement
Table of Contents
Troubleshooting
