Scotsman MC 15 Service Manual page 9

Page 9
5. Put the Electronic Modular cuber on top of
the Electromechanical unit securing them by
means of the bolts and nuts found in the hardware
package supplied with the machine.
6. Remove the ice chute from both the unit and
insert, through the ice discharge opening of the
upper unit, the plastic reinforced Ice Chute
Connection.
7. Disconnect the ice level control terminal
plug from the P.C. BOARD of Electronic Modular
Cuber.
8. Install and fasten the ice level control assy
on its bracket by means of the two screws found
in the hardware package supplied with the unit.
9. Direct ice level control cable first to pass
through the ice discharge opening of the bottom
machine with the protective sheath correctly
located in correspondance of this opening and
then to pass through the round hole provided into
the base of the Electronic Modular Cuber (Upper
unit).
10. Connect the electric plug of the ice level
control cable to the Cable Extension, then plug-
in this one into its P.C. BOARD socket.
11. Rotate the TRIMMER setting screw located
in the front of P.C. BOARD clockwise, to its
maximum power, so to compensate the greater
resistence caused by the addition of the Cable
Extension.
12. Stick, with accuracy, the rubber stripe onto
the upper edge of the front panel of the lower unit
in order to fill the air gap between the two
machines.
13. Place again in their position the two ice
chutes and finally re-fit all the service panels
previously removed.
Page 9