Table of Contents
Advertisement
Page 7
GENERAL INFORMATION AND INSTALLATION
A.
INTRODUCTION
This manual provides the specifications and the
step-by-step procedures for the installation, start-
up and operation, maintenance and cleaning for
the SCOTSMAN MODULAR CUBERS.
The Electronic Modular Cubers are quality
designed, engineered and manufactured.
Their ice making systems are thoroughly tested
providing the utmost in flexibility to fit the needs
of a particular user.
These icemakers have been engineered to our
own rigid safety and performence standards.
NOTE. To retain the safety and performance
built into this icemaker, it is important that
installation and maintenance be conducted
in the manner outlined in this manual.
Storage Bin
Since the MC series Modular Cubers do not
have their own attached ice storage bins, it is
necessary to use an auxiliary bin such as the Bin
B 350 or B 550.
B.
UNPACKING AND INSPECTION
Modular Cuber
1.
Call your authorized SCOTSMAN Distributor
or Dealer for proper installation.
2.
Visually inspect the exterior of the packing
and skid. Any severe damage noted should be
reported to the delivering carrier and a concealed
damage claim form filled in subjet to inspection
of the contents with the carrier's representative
present.
3.
a) Cut and remove the plastic strip securing
the carton box to the skid.
b) Remove the packing nails securing the
carton box to the skid.
c) Cut open the top of the carton and remove
the polystyre protection sheet.
d) Pull out the polystyre posts from the
corners and then remove the carton.
4.
Remove top and sides panels of the unit
and inspect for any concealed damage. Notify
carrier of your claim for the concealed damage
as stated in step 2 above.
5.
Loose two nuts on left and rights side of the
unit base and remove it from the skid. Save the
two bolts and nuts to mount the machine on
storage bin or on top of another Modular Cuber.
6.
Remove all internal support packing and
masking tape and the hardware package.
7.
Check that refrigerant lines do not rub
against or touch other lines or surfaces, and that
the fan blade moveS freely.
8.
Check that the compressor fits snugly onto
all its mounting pads.
9.
See data plate on the rear side of the unit
and check that local main voltage corresponds
with the voltage specified on it.
CAUTION. Incorrect voltage supplied to
the icemaker will void your parts
replacement program.
10. Remove the manufacturer's registration
card from the inside of the User Manual and fill-
in all parts including: Model and Serial Number
taken from the data plate.
Forward the completed self-addressed
registration card to Frimont/Scotsman Europe
factory.
Storage bin
1.
Follow the steps 1, 2 and 3 above to unpack
the storage bin.
2.
Unloose the two bolts and remove the
protection plate from the drain fitting.
3.
Carefully lay it down on its rear side and fit
the four legs into their sockets.
4.
Remove all internal support packing and
masking tape as well as the plastic ice cube
deflector.
5.
Remove the manufacturer's registration
card from the inside of the User Manual and fill-
in all parts including: Model and Serial Number
taken from the data plate.
Forward the completed self-addressed
registration card to Frimont/Scotsman Europe
factory.
Page 7
Hide quick links:
Advertisement
Table of Contents
