Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
You will need the following equipment to complete the hob
installation satisfactorily:
•
Gas Pressure tester
•
Flexible gas hose
•
Multimeter
You will also need the following tools:
1.
Electric drill
2.
Jigsaw
3.
Steel tape measure
4.
Cross head screwdriver
5.
Pencil
6.
Adjustable spanner
7.
Sharp knife
Checking the Parts
Check that the appliance is in a good condition after having
removed the packaging. In case of doubt, do not use the
appliance and contact the retailer.
The hob also has 3 pan supports.
Never leave the packaging materials (cardboard,
plastic bags, polystyrene foam, etc.) within children's
reach since they could become potential sources of
danger.
Positioning the Hob
The hob should be fitted into a work surface, which is at least
600 mm deep. In position, the hob has a maximum thickness
of 50 mm from the top of the work surface, and an overall
thickness of 100 mm (120 mm max depth including the gas
connector). The cut-out dimensions are shown in (Fig.5-1),
and the minimum clearances in (Fig.5-2).
It is recommended that the hob be installed in a worktop
with a minimum thickness of 40 mm.
Note: If installing the hob over a standard cabinet, you may
have to remove part of the cabinet panels to allow the unit to
fit correctly (Fig.5-1).
It is recommended that there is a minimum air gap of 100 cm²
underneath the hob to allow sufficient air circulation to the unit.
If installing a built-in oven directly under the hob then there
should be a minimum air gap of 20 mm between the oven and
the bottom of the hob. Failure to maintain a suitable clearance
may impair the performance of the hob.
Any hob hood should be installed in accordance with the
hood manufacturer's instructions.
Surfaces of furniture and walls at the sides and rear of the hob
should be heat, splash and steam resistant. Certain types of
vinyl or laminate kitchen furniture are particularly prone to
heat damage and discolouration.
INSTALLATION
720
Cut-outs in cabinet sides
to allow hob to sit across
ArtNo.316-0028 - RGG77 cut-out dimensions
ArtNo.316-0014 RG60 hob clearances
9
510 mm
480 mm
560
600mm min
55mm min
150mm
min
Fig.5-1
50 mm
(70mm including
gas connector)
Fig.5-2
21mm
min
Fig.5-3
650mm min
150mm
min
Advertisement
Table of Contents
