Kenwood KMD-673R Instruction Manual page 33

Md-receiver
Hide thumbs Also See for KMD-673R:
Table of Contents

Advertisement

PROBLEM
The sound skips.
The display shows that the
changer is being played, but no
sound can be heard.
The specified track does not
play.
Track repeat, disc repeat, track
scan, random play, and
magazine random play start by
themselves.
Cannot play CD-R or CD-RW
Can't remove disc.
"AUX" is displayed without
achieving External disc control
mode.
If the following situations, consult your nearest service centre:
• Even though the disc changer is connected, the Disc Changer Mode is not on, with "AUX" showing in the display during the Changer
Mode.
• Even though no device (KCA-S210A, CA-C1AX,KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected,
the AUX Mode is entered when switching modes.
POSSIBLE CAUSE
Something is touching the disc changer.
The CD is scratched or dirty.
The computer chip in the unit is not functioning normally.
Random play or magazine random play has been
selected.
The setting is not canceled.
Finalization processing is not being conducted for CD-
R/CD-RW.
A non-compatible CD changer is being used to play the
CD-R/CD-RW.
The cause is that more than 10 minutes has elapsed
since the vehicle ACC switch was turned OFF.
O-N switch is set to "O" side.
Unsupported disc changer is connected.
Remove whatever is touching it.
If skipping happens at the same place when the car is
stopped, something is wrong with the CD. Clean the CD.
Press the reset button on the unit (see page 4).
Turn off the random play or magazine random play
function.
The settings for these functions remain on until the
setting to off or the disc ejected, even if the power is
turned off or the source changed.
Conduct finalization processing with CD recorder.
Use a CD changer compatible with CD-R/CD-RW to play.
The disc can only be removed within 10 minutes of the
ACC switch being turned OFF. If more than 10 minutes
has elapsed, turn the ACC switch ON again and press
the Eject button.
Set the switch to "N" side.
Connect the supported disc changer. (see page 3)
— 33 —
SOLUTION

Advertisement

Table of Contents
loading

Table of Contents