Table of Contents
Advertisement
Installation
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the
two locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
Accessory2 Removal tool
2
When the lower level is removed, remove the upper two
locations.
NOTE
The frame can be removed from the top side in the same
manner.
1
2
3
Catch
Lock
4
Be careful to avoid injury from the catch pins on the removal
tool.
5
— 30 —
Removing the Unit
Refer to the section "Removing the hard rubber frame" and
then remove the hard rubber frame.
Remove the screw (M4´8) on the back panel.
Insert the two removal tools deeply into the slots on each
side, as shown.
Screw (M4X8)
(commercially
available)
Lower the removal tool
toward the bottom, and
pull out the unit halfway
whilst pressing towards the
inside.
2CAUTION
Pull the unit all the way out
with your hands, being
careful not to drop it.
Catch facing up
Accessory2 Removal tool
Advertisement
Table of Contents
