Table of Contents
Advertisement
Troubleshooting Guide
MD/External disc control mode
PROBLEM
The MD cannot be inserted.
The MD does not load.
The MD loads but soon comes
out again.
The sound skips.
There is noise during playback.
The disc control mode cannot
be selected.
The specified disc does not
play, but another one plays
instead.
POSSIBLE CAUSE
There is already an MD loaded.
The insertion orientation of the MD is incorrect or the MD
is upside down.
Nothing is recorded on the MD.
The mounting angle exceeds 30°.
The mounting is unstable.
The MD is soiled with dust or dirt.
No cable has been connected to the disc changer input
terminal on the unit.
The specified CD is very dirty.
The CD is upside-down.
The disc is loaded in a different slot from that specified.
The disc is severely scratched.
Eject the currently loaded MD and then load the new one.
Insert the MD in the proper orientation.
Replace the MD with one that is recorded.
Adjust to an angle of less than 30°.
Fix the unit securely. When the sound skips at the same
portion even when the car is stopped, the problem lies
with the MD.
If another MD is played back and there is no problem,
then the problem is due to the sound quality of the MD
itself.
Connect the cable to the disc changer input terminal on
the unit.
Clean the CD.
Load the CD with the labelled side up.
Eject the disc magazine and check the number for the
specified disc.
Try another disc instead.
— 32 —
SOLUTION
Advertisement
Table of Contents
