Table of Contents
Advertisement
Quick Links
Network Pro Series
Tower and Rack-Mount
Convertible UPS
User Manual
1000/1500/2200/3000
Table of Contents
1
Introduction ------------------------------------------------------------------------------------2
2
IMPORTANT SAFETY INSTRUCTION -------------------------------------------------3
2.1
An Important Notice ------------------------------------------------------------3
2.2
Storage Instruction --------------------------------------------------------------5
3
SET UP -----------------------------------------------------------------------------------------6
3.1
Inspection ------------------------------------------------------------------------6
3.2
Place the UPS Properly---------------------------------------------------------6
3.3
Unpacking------------------------------------------------------------------------7
3.4
Selecting Installation Position -------------------------------------------------8
3.5
UPS Setup------------------------------------------------------------------------8
3.6
Tower Setup ---------------------------------------------------------------------9
3.7
Rack-Mount Setup ------------------------------------------------------------ 10
3.8
UPS Front Panel--------------------------------------------------------------- 12
3.9
LCD Display Panel ----------------------------------------------------------- 13
3.10
UPS Rear Panel --------------------------------------------------------------- 14
4
INSTALLATION --------------------------------------------------------------------------- 19
4.1
Connect Utility and Load ---------------------------------------------------- 19
4.2
Connect Network Surge protection ----------------------------------------- 20
4.3
Connect Computer Interface Port ------------------------------------------- 20
4.4
REPO Switch ------------------------------------------------------------------ 21
5
OPERATION -------------------------------------------------------------------------------- 22
5.1
Turn on the UPS--------------------------------------------------------------- 22
5.2
Turn Off the UPS ------------------------------------------------------------- 22
5.3
Plug-in Charge----------------------------------------------------------------- 22
5.4
Auto-Restart ------------------------------------------------------------------- 24
5.5
Alarm Silence------------------------------------------------------------------ 24
5.6
Self Test ------------------------------------------------------------------------ 24
6
UPS MAINTENANCE --------------------------------------------------------------------- 25
6.1
Battery Replacement---------------------------------------------------------- 25
6.2
How to Replace Battery ------------------------------------------------------ 26
6.3
Recycling the Used battery -------------------------------------------------- 28
7
Communication ------------------------------------------------------------------------------ 29
7.1
DB-9 Connector --------------------------------------------------------------- 29
8
Optional Communication Cards ----------------------------------------------------------- 30
8.1
DCE (Dry Contact) card ----------------------------------------------------- 30
8.2
SNMP Web Card - Ethernet ------------------------------------------------- 31
9
SPECIFICATIONS ------------------------------------------------------------------------- 32
9.1
120V ---------------------------------------------------------------------------- 32
1
Advertisement
Table of Contents
Related Manuals for Orion Network Pro 1000
Summary of Contents for Orion Network Pro 1000
-
Page 1: Table Of Contents
Table of Contents Introduction ------------------------------------------------------------------------------------2 IMPORTANT SAFETY INSTRUCTION -------------------------------------------------3 An Important Notice ------------------------------------------------------------3 Storage Instruction --------------------------------------------------------------5 SET UP -----------------------------------------------------------------------------------------6 Inspection ------------------------------------------------------------------------6 Place the UPS Properly---------------------------------------------------------6 Unpacking------------------------------------------------------------------------7 Selecting Installation Position -------------------------------------------------8 UPS Setup------------------------------------------------------------------------8 Tower Setup ---------------------------------------------------------------------9 Rack-Mount Setup ------------------------------------------------------------ 10 UPS Front Panel--------------------------------------------------------------- 12 LCD Display Panel ----------------------------------------------------------- 13 3.10 UPS Rear Panel --------------------------------------------------------------- 14... -
Page 2: Introduction
4. Do not try to repair the unit yourself; contact your local supplier or Orion Power Systems Technical support if the unit needs repair. 90% high efficiency design when used in Normal mode meets high efficiency energy saving standards and reduces noise and heat. -
Page 3: Storage Instruction
24. CAUTION - RISK OF EXPLOSION IF BATTERY IS REPLACED BY 14. The battery should be recharged every 2-3 months if the UPS is not AN INCORRECT TYPE. DISPOSE OF USED BATTERIES in service. This can be done by plugging in the UPS for a minimum ACCORDING TO THE INSTRUCTIONS. -
Page 4: Set
SET UP 3.3 Unpacking 3.1 Inspection 1. Take the UPS out of the packing foam. 2. Remove the packing materials. Inspect the UPS upon receipt. Notify the carrier and dealer if there is 3. Standard Package includes: damage to the shipping carton or the UPS. If shipping damage is present, a. -
Page 5: Selecting Installation Position
3.4 Selecting Installation Position 3.6 Tower Setup In order to minimize the possibility of damage to the UPS and extend Stand alone unit the life of the UPS, it is necessary to select a proper environment to install the unit. Please follow the instructions below: 1. -
Page 6: Rack-Mount Setup
Step3 3.7 Rack-Mount Setup Step1 Step4 Step2 Step5... -
Page 7: Ups Front Panel
3.9 LCD Display Panel 3.8 UPS Front Panel 1. Utility LED 2. Fault LED 3. On Switch 4. Off Switch 5. Battery Replacement 6. Battery Backup LED 7. Battery Low 8. Bypass 9. Utility Low, UPS Boost 10. Utility High, UPS Buck 11. -
Page 8: Ups Rear Panel
3.10 UPS Rear Panel 2200VA 120V(1920VA/1920W for UL) 750 / 1000 / 1500VA 120V Item Description Data Line Connectors Item Description Voltage Configuration Switch Data Line Connectors USB Port Voltage Configuration Switch RS232 (DB-9) Port USB Port 15A Output Circuit Breaker for 6-1 RS232 (DB-9) Port 20A Output Circuit Breaker for 6-2 NEMA 5-15R Output Receptacles... - Page 9 3000VA 120V 750/ 1000/ 1500VA 230V Item Description Item Description Data Line Connectors Data Line Connectors Voltage Configuration Switch Voltage Configuration Switch USB Port USB Port RS232 (DB-9) Port RS232 (DB-9) Port 15A Output Circuit Breaker for 6-1 IEC-320-C13 Output Receptacles 20A Output Circuit Breaker for 6-2 Cooling Fan NEMA 5-15R Output Receptacles...
-
Page 10: Installation
INSTALLATION 2200/ 3000VA 230V 4.1 Connect Utility and Load First, connect the UPS with utility power, then plug the loads into the outlets on the rear of the UPS. To use the UPS as a master “On/Off” switch, make sure that all of the loads are switched “on”. These UPS outlets provide battery backup and surge protection to the equipment when utility voltage is out of specification. -
Page 11: Connect Network Surge Protection
4.4 REPO Switch 4.2 Connect Network Surge protection The UPS is equipped with an Emergency Power Off (EPO) switch. The user must supply a means of interfacing with the EPO circuit to allow Connect a 10 base-T / 100 base-T network cable to the RJ-45 network disconnecting the UPS input feeder breaker to interrupt all sources of surge protection “IN”... -
Page 12: Turn On The Ups
2. If the UPS is not in active use, charge the battery for at least 8- OPERATION 12 hours every 3 months to keep the batteries in good working condition. 5.1 Turn on the UPS 1. Connect the UPS to the wall receptacle. LCD will display “OFF”, when Utility is normal. -
Page 13: Auto-Restart
If the battery is detected as weak or in Backup mode. dead, the Battery Replacement LCD will be illuminated. Please contact Orion Power Systems Technical Support for battery replacement information. Caution--- The UPS will not provide power to the outlets if the if the start- up operation is not completed properly. -
Page 14: How To Replace Battery
STEP 3 6.2 How to Replace Battery STEP 1 STEP 4 STEP 2 750/ 1000/ 1500VA... -
Page 15: Recycling The Used Battery
2200/ 3000VA Communication 7.1 DB-9 Connector The UPS has a DB-9 (9 pin female) connector on the rear to allow UPS status communications with a computer running UPS software. The connection provides serial communication, On Battery and Low Battery signals. Table 4 DB-9 pin assignment DB-9 Pin... -
Page 16: Optional Communication Cards
8.2 SNMP Web Card - Ethernet Optional Communication Cards 8.1 DCE (Dry Contact) card 8.2.1. For installation, please refer to the user’s manual attached with the card. 8.2.2. Installation Position：Optional Slot ： 8.1.1 The pin assignments of 10-Pin Terminal 1 N/A 2 ... -
Page 17: Specifications
SPECIFICATIONS Backup Time * 9.1 120V 1000VA 1500VA 2200VA 3000VA Model number 750/1000VA 1500VA 2200VA 3000VA Full Load Power Rating, VA/W 750VA/750W Half Load 1500VA/1350W 1920VA/1920W 3000VA/2700W 1000VA/900W Recharge Time 5 hours to 90% of rated capacity, after full discharge into resistive load Dimensions, W x D x H, in Environmental Unit... - Page 18 Orion Power Systems Service and Technical Support If you have any problems or questions with the UPS, call your local distributor or Orion Power Systems technical support at the following telephone number : In the United States: 1-877-385-1654 Please have the following information ready when you call:...