Interrupt Copying - Kyocera Mita KM-1530 Instruction Handbook Manual

CHAPTER 4 BASIC OPERATIONS
I n t e r r u p t c o p y i n g i s u s e f u l i f , d u r i n g o n e c o p y j o b , o t h e r o r i g i n a l s n e e d
t o b e c o p i e d a t d i f f e r e n t s e t t i n g s . T h e i n t e r r u p t e d j o b c a n b e r e s u m e d
at the same settings as before, after the rush job is finished.
1
Press the Interrupt key. When interrupt copying is enabled,
t h e I n t e r r u p t i n d i c a t o r l i g h t s .
2
R e m o v e t h e p r e s e n t o r i g i n a l ( s ) a n d p u t i t a s i d e .
3
S e t t h e n e w o r i g i n a l ( s ) a n d e x e c u t e c o p y i n g .
4
When copying ends, press the Interrupt key again and
replace the newly copied original(s) with the one(s) removed
b e f o r e . T h e n , p r e s s t h e S t a r t k e y . T h e i n t e r r u p t e d c o p y j o b
w i l l b e r e s u m e d .
Approximately 120 seconds after the end of interrupt
c o p y i n g , t h e a u t o c l e a r f u n c t i o n w i l l b e t r i g g e r e d . T h e
I n t e r r u p t i n d i c a t o r g o e s o u t a n d t h e c o p i e r w i l l b e r e a d y t o
r e s u m e t h e i n t e r r u p t e d c o p y j o b .