Drawer Microwave Oven Installation - Wolf 24" User Manual

Drawer Microwave Oven Installation

Installation
UNPACK THE OVEN
Remove all packing materials from inside the drawer
microwave oven. Do not remove the waveguide cover,
which is located on the upper surface of the drawer
interior. Refer to the illustration below.
Remove the feature sticker, if applicable. Check the
microwave oven for any signs of damage, such as dents,
a misaligned or bent drawer, damaged drawer seals and
sealing surfaces or broken or loose drawer guides. If any
damage is found, contact your authorized Wolf dealer or
a Wolf authorized service center. Do not operate the
microwave oven.
WAVEGUIDE
COVER
Location of waveguide cover.
INSTALL THE OVEN
1) Turn power off to the electrical outlet.
2) Place the drawer microwave oven close to the
prepared rough opening. Plug the power cord into the
grounded electrical outlet.
3) Carefully guide the microwave oven into the opening.
Avoid pinching the power cord between the unit and
the cabinet wall.
4) Slide the microwave oven all the way into the opening
until the mounting flange is flush with the face of the
cabinet.
5) Open the drawer. Using the four holes on the mounting
flange as a template (two on each side), pre-drill
mounting holes into the cabinet using a
6) Mount the microwave oven with the four screws
provided. Refer to the illustration below.
7) Turn power back on to the electrical outlet.
MOUNTING
FLANGE
Mount the microwave oven.
10
1
/ " bit.
16