Download Print this page
Wolf 30" Installation Manual

Wolf 30" Installation Manual

Cooktop ventilation hoods

Advertisement

Cooktop Ventilation Hoods Installation Guide

Advertisement

loading

Summary of Contents for Wolf 30"

  • Page 1 Cooktop Ventilation Hoods Installation Guide...
  • Page 2 WARNING most up-to-date information. death if precautions are not followed. Throughout this guide, dimensions in IMPORTANT NOTE: parentheses are millimeters unless otherwise specified. Save these instructions for the local IMPORTANT NOTE: electrical inspector. Wolf Customer Care 800.222.7820...
  • Page 3 (filters must be removed). Refer to the illustration below. If service is necessary, contact Wolf factory certified ser- vice with the model and serial number. For the name of the nearest Wolf factory certified service or for questions regarding the installation, visit the contact &...
  • Page 4: Installation Requirements

    Wolf induction, electric and gas cooktops and inte- with local codes or, in the absence of local codes, with the grated modules. For ranges and rangetops, a Wolf pro venti- National Electrical Code, ANSI/NFPA 70. lation hood is recommended.
  • Page 5 Contact your local HVAC professional for specific requirements. A make-up air damper is available through an authorized Wolf dealer. For local dealer information, visit the find a showroom section of our website, wolfappliance.com. wolfappliance.com...
  • Page 6 Stainless Hood " (416) Glass Hood " (319) LEVELING SCREW MOUNTING CEILING 3 /4 " (19) 1 /16 " (433) 1 /8 " (232) Mount and level hood. Install telescopic flue. BOTTOM OF HOOD Mounting location. Wolf Customer Care 800.222.7820...
  • Page 7 INSTALLATION Installation ISLAND HOOD Place the damper on the support frame then attach duc- twork to the damper. If an internal blower is being installed, install the blower prior to mounting the hood. Refer to page 8 for internal blower Slide the upper chimney flue onto the support frame and installation.
  • Page 8 Insert the plug from the blower wire into the receptacle on the blower. Refer to the illustration below. Secure the blower to the hood using the two mounting screws provided. RECEPTACLE MOUNTING RECEPTACLE SCREW Hood receptacle. Mount blower. Wolf Customer Care 800.222.7820...
  • Page 9 INSTALLATION Wiring Connections INTERNAL BLOWER WIRING IN-LINE / REMOTE BLOWER WIRING Remove the top cover of the electrical box by extracting Remove the top cover of the electrical box by extracting two screws. Refer to the illustration below. two screws. Refer to the illustration below. Remove the two existing wires from the left side of Remove one of the round knockouts using a flat blade the terminal block and transition them to the right and...
  • Page 10: Troubleshooting

    Verify proper wiring connections. • If the ventilation hood does not operate properly, contact Wolf factory certified service. Do not attempt to repair the hood. Wolf is not responsible for service required to correct a faulty installation. Wolf Customer Care 800.222.7820...
  • Page 11 Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc. Sub-Zero, Sub-Zero & Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service marks of...
  • Page 12 WOLF APPLIANCE, INC. P.O. BOX 44848 MADISON, WI 53744 WOLFAPPLIANCE.COM 800.222.7820 000000 REV-A 4 / 2014...

This manual is also suitable for:

36"Vw30b