~~------------------
~
946261-9701
(A) 137236 (990-1077-15-5)
Figure 2-7. Location of Electronics Cover Screws
12. Press in on outboard end of card cage cover clamp (Figure 2-9) and move clamp end for-
ward until free of screw. Lift up on free end of clamp to release end hooked onto inboard
side of card cage.
13. Lift card cage cover off and set aside.
NOTE
Refer to Figure 2-10 for steps 14 through 23.
NOTE
The following steps are necessary only if a problem occurs during
installation.
14. Remove control PWB and verify that SI settings are as shown in Figure 2-11.
15. Replace control PWB.
16. Remove sector PWB and verify that switch settings are as shown in Figure 2-12.
17. Replace sector PWB.
18. Remove servo PWB and verify that switch settings are as shown in Figure 2-13.
2-10
Digital Systems Division