Attenuator; Audio Control; Subwoofer Output - Kenwood KDC-W8534 Instruction Manual

Attenuator

Turning the volume down quickly.
Press the [ATT] button.
Each time you press the button, the Attenuator
turns ON and OFF.
When the Attenuator is ON, "ATT" is displayed.

Audio Control

1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Audio item
Turn the [VOL] knob.
Adjustment Item Display
1
Rear Volume * "Rear Volume" 0 — 35
2,3
Subwoofer level* "Sub-W Level" –15 — +15
Balance "Balance"
3
Fader* "Fader"
Exit Audio Control mode (Volume control mode)
1
• * You can control this item when "2 ZONE" of <Audio
Setup> (page 12) is set to "ON".
2
• * You can control this item when Speaker Select
Subwoofer of <Sound Management system> (page
14) is set to any item other than "None".
3
• * You can control this item when <Subwoofer
Output> (page 11) is set to "SW ON".
3
• * You can control this item when "2 ZONE" of <Audio
Setup> (page 12) is set to "OFF".
5
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob, [ANG]
and [ATT] button.
Range
Left 15 — Right 15
Rear 15 — Front 15

Subwoofer Output

Turning the Subwoofer output ON or OFF.
Push the Control knob toward [AM] for at
least 2 seconds.
Each time you press the button, Subwoofer
output switches ON and OFF.
When it is ON, "SW ON" is displayed.
• You can control this item when Speaker Select
Subwoofer of <Sound Management system> (page
14) is set to any item other than "None".
• You can control this function when "2 ZONE" of
<Audio Setup> (page 12) is set to "OFF".
11
|
English