Sound Management System - Kenwood KDC-W8534 Instruction Manual

General features

Sound Management system

1
Select the source to adjust
Press the [SRC] button.
2
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "S.M.S" is
displayed above the [2] button.
Refer to <Notes on Multi-function Key System>
(page 9).
3
Enter Sound Management mode
Press the [2] ("S.M.S") button.
• When "2 ZONE" of <Audio Setup> (page 12) is ON,
you cannot select "S.M.S".
4
Select the Sound Management item to
adjust
Press a [1] — [5] button.
Multi-function key operation
[1] "CABIN"
[2] "F"
[3] "R"
[4] "SW"
[5] "Preset" [1] "RCL"
[2] "MEM"
• "Preset": You can store an adjusted sound
management system value by selecting
"MEM". Refer to <Memory mode> (page 17).
Also, you can recall it by selecting "RCL". Refer
to <Memory Recall mode> (page 17).
5
Adjust the Sound Management item
Push the Control knob towards [4] or
[¢].
Each time you push the knob, the setting
alternates between the settings shown in the
table below.
14
|
English
Sound Management Item
Cabin Setting
Speaker Select Front
Speaker Select Rear
Speaker Select Subwoofer
Recall mode
Memory mode
Sound Managemnt Item Range
Cabin Setting
Speaker Select Front
Speaker Select Rear
Speaker Select Subwoofer
6
Exit Sound Managemnt mode
Press the [6] ("RTN") button.
OFF/ Compact/ Sedan/ Wagon1/
Wagon2/ Mini Van1/ MiniVan2/ SUV/
Passenger Van
16cm/ 17cm/ 18cm/ 4x6/ 5x7/ 6x8/ 6x9/
7x10/ O.E.M./ 10cm/ 13cm
16cm/ 17cm/ 18cm/ 4x6/ 5x7/ 6x8/ 6x9/
7x10/ None/ O.E.M./ 10cm/ 13cm
25cm/ 30cm/ 38cm over/ None/
16cm/ 20cm