External Display Switching - Kenwood KDC-W7031 Instruction Manual

• G-Graphic display
Displays the condition of G on horizontal direction
(e.g; when turning the curve) by the graphic.
• G-Meter display (Graphic)
Displays the maximum value of acceleration G, right
direction G, and left direction G by the numerical
value.
• G-Meter display (Text)
The maximum value of acceleration G, right direction
G, and left direction G is displayed by the numerical
value. The value of G is only the reference so it is
differed from the actual value.
• G-Counter display
Adds the point of the acceleration level. The point
is determined after a lapse of 1 hr drive or at power
off (ex; ACC Off ), and then it will be displayed by the
graph. Furthermore, it displays the average of the past
data by the line. (The scale of graph is determined
along with the largest point among the past 10 data.)
• The value of G-Meter display and G-Counter display
can be reset by <G-Analyzer Reset> (page 37).
7
Exit display control mode
Press the [6] ("RTN") button.

External Display Switching

Switching the display in the External Display
connected.
1
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [2] button.
Refer to <Notes on Multi-function Key System>
(page 9).
2
Enter display control mode
Press the [2] ("DISP") button.
3
Enter External Display Select mode
Press the [5] ("OUT") button.
"OEM DISP" is displayed.
4
Select the display
Push the Control knob to [4] or [¢].
Each time the button is pressed the display
switches.
5
Exit display control mode
Press the [6] ("RTN") button.
21
|
English