Audio Control - Kenwood KDC-W707 Instruction Manual

Audio Control

1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Basic Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Basic Audio item
Turn the [VOL] knob.
Adjustment Item Display
Rear Volume * 1 "R-Volume"
Subwoofer level* 2,3 "SW_Level"
4
Bass level* "Bass Level"
Middle level* 4 "Middle Level" –8 — +8
4
Treble level* "Treble Level"
Balance "Balance"
3
Fader* "Fader"
Exit Audio Control mode
1
• * You can control this item when "2Zone" of <Audio
Setup> (page 12) is set to "ON".
2
• * You can control this item when <Switching preout>
(page 33) is set to "SWPRE:Sub-W". (KDC-W707 only)
3
• * You can control this item when <Subwoofer
Output> (page 12) is set to "SW ON".
• * 3 You can control this item when "2Zone" of <Audio
Setup> (page 12) is set to "OFF".
• * 4 You can adjust these items in detail by the following
methods. (Function of the KDC-W808)
4
• * Source tone memory: Puts the set up value in the
memory per source. (Detail Audio item is included)
5
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob and
[ATT]/ [ANG] button.
Range
0 — 35
–15 — +15
–8 — +8
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15
Adjust the detail of Audio Control
1 Select the Audio item to adjust
By referring to the step 1 — 3 above, select the
desired item to be set in detail from the items
4
marked with * .
2 Enter Detail adjustment mode of Audio
Control
Press the [VOL] knob for at least 1 second.
3 Select the Detail Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown
in the table below.
4 Adjust the Detail Audio item
Turn the [VOL] knob.
Bass level
Adjustment Item Display
Bass Center Frequency "Bass Freq"
Bass Q Factor "Bass Q"
Bass Extend "Bass EXT"
Middle level
Adjustment Item Display
Middle Center Frequency "Middle Freq" 0.5/1.0/1.5/2.0 kHz
Middle Q Factor "Middle Q"
Treble level
Adjustment Item Display
Treble Center Frequency "Treble Freq" 10.0/12.5/15.0/17.5 kHz
5 Exit the Detail Audio Control mode
Press the [VOL] knob for at least 1 second.
• When you set the Bass Extend to ON, low frequency
response is extended by 20%.
• You can exit the Audio Control mode at anytime by
pressing any button except for [VOL], [ANG] and [ATT]
buttons.
Range
40/50/60/70/80/100/
120/150 Hz
1.00/1.25/1.50/2.00
ON/OFF
Range
1.0/2.0
Range
11
|
English