Memory: What Is Saved? And Where - Planar Bobcat X SN-4045-WX User Manual

3.5.4 Memory: What Is Saved? And Where?

In the Bobcat X some parameters (values) are associated
with the mode. The mode is primarily the horizontal and
vertical resolution and the vertical frequency of the incom-
ing source picture. It is more than this, but if you think of it
this way, you will be close enough.
Some parameters are associated with the input. The
input in this instance means the input connector: Analog 1,
Digital, Composite Video, etc.
✎
The parameters specific to Mode and Input are
saved in memory slots.
Some parameters are global, that is, they are not associ-
ated with either the mode or the input connector, and are
not saved to memory slots. They are universal.
Parameter
ASCII Response Term.
ASCII Response Type
Auto Codes
Auto Backlight On
Baud Rate
Black Level: R, G, & B
Brightness (video)
Color Balance (all values)
Colorspace
Contrast (video)
Curtain Pattern
Do Black/White Levels
Do Frequency
Do Phase
Do Position
Frequency
Group ID
Hue
Justify
Specific to the
Global
Mode Input
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
Parameter
Menu H Position
Menu Timeout
Menu V Position
Phase
Plug and Play (EDID)
Position, Horizontal
Position, Vertical
Resolution, Horizontal
Resolution, Vertical
Retry On Lost Signal
Saturation
Sharpness
Unit ID
White Level: R, G, & B
Memory
The Bobcat X remembers the last 10 modes it received
and all the mode parameters associated with them.
Switching modes
For instance, suppose you set up the Black and White
Levels for a 1024x768 @ 65Hz vertical from a computer
connected to Analog. Then later, using the same input con-
nector but a different computer you set up the Bobcat X for
a 1600x1200 @ 60Hz. You re-adjust the Black and White
Levels, because they are different.
Still later you plug in the first computer with its
1024x768 @ 65Hz picture. Immediately, the Bobcat X rec-
ognizes that it has seen this signal type before, and it recalls
the Black and White Levels from its internal memory.
It does not Do Frequency or Phase or anything else,
because it recognizes that this input was used before, and
the previous settings are probably correct.
Possible issue with Mode specific memory
Suppose that after setting up the 1024x768 and
1600x1200 pictures, you connect a third computer that is
Specific to the
Global
Mode Input
x
x
x
x
x
x
x
x
x
x
x
x
x
x
54