Table of Contents
Advertisement
Dry Vacuum Cleaning
6.1 Before dry vacuum cleaning
43
So that you can use the wet/dry vacuum cleaner as a dry vacuum cleaner, the motor protection filter must be
attached. Therefore, proceed as follows to ensure that the motor protection filter is installed correctly.
1. Switch the appliance off and pull the appliance plug out of the socket.
2. Release the motor unit from the dirt tank by bending both retaining clips upwards
(Fig. 43, rear retaining clip covered).
3. Take the motor unit up out of the dirt tank.
filter of the vac".
Align the rubber band so that it is between both the lines and as close to the basis as possible.
CAUTION: Use the dry/wet vacuum cleaner for dry cleaning only if an intact motor protection filter
is installed correctly.
4. Put the motor unit including the motor protection filter powerfully onto the dirt tank until you can hear and
feel both retaining clips snap into place.
5. If you have not done so already, insert the suction hose powerfully into the connecting piece at the motor unit
that is marked with 'VACUUM' (Fig. 45).
38
44
45
Hide quick links:
Advertisement
Table of Contents
