Applying Cleaning Agent - Ryobi R2-PWWDV-G Original Instructions Manual

High-pressure cleaning

4.9 Applying cleaning agent

CAUTION: Protect the environment! Always only use the quantity of cleaning agent that you
actually require.
NOTE: If you soak the dirt with cleaning agent before high-pressure cleaning, cleaning is faster.
31
Apply cleaning agent over a broad area (to soften dirt before cleaning):
1. Assemble the lance, Chapter 4.1, "Connecting attachments to pistol".
2. Set the lance so that the spray angle is wide or at the maximum setting (Fig. 31).
3. Turn the control knob of the tank filled with cleaning agent (Fig. 32).
4. Moisten the surface to be cleaned with a cleaning-agent-water mix.
5. Allow the mix to work for 5–10 minutes and then clean as before with the high-pressure jet.
Adding cleaning agent whilst high-pressure cleaning:
1. Turn the control knob of the tank filled with cleaning agent (Fig. 32).
2. If it is obvious that no more cleaning agent is being discharged, the selected tank is empty.
Switch to the other tank (Fig. 32).
3. If this tank is also empty, refill the tanks, Chapter 4.2, "Filling the cleaning agent tanks (only when required)".
32
32