Using Your Speakerphone; Answering A Call - ClearSounds CSC500 Operating Manual

█ Using your Phone with Hearing Aids and
Cochlear Implants
Your phone can be used with hearing aids and cochlear implants
equipped with a telecoil (T-coil). Adjust your hearing aid "T-
switch" to the "T" position. Make sure to hold the handset
close to your T-coil.
█

Using your Speakerphone

For optimal speakerphone performance, avoid the following:
• Areas with high background noise (The microphone might
pick up these sounds and prevent the speakerphone from
going into the receiving mode when you finish talking).
• Surfaces affected by vibration.
• Recessed areas such as in a corner, under a cupboard, or
next to a cabinet, which can generate an echo effect.

█ Answering a Call

NOTE: Make sure the ringer switch is set to HI or LO to hear
the audible ring. If you have selected OFF, the visual flasher
will be your only ring notification.
Using the Handset
1. To answer a call, lift the handset and speak. You will see
the In Use LED indicator light up.
2. Adjust your volume and tone settings if needed.
3. To end the call, replace the handset on the base.
Using the Speakerphone
1. To answer a call, press the Speaker key on the base.
You will see the In Use LED indicator light up.
2. Adjust your volume by using the volume control V- or
V+ located on right side of the phone.
3. To end the call, press the Speaker key again on the
base.
11 – ENGLISH